I need a course in R-Pod water Heater 1001 |
Post Reply | Page <1 3456> |
Author | |
vandallc
Groupie Joined: 02 May 2010 Location: Charleston, SC Online Status: Offline Posts: 41 |
Topic: I need a course in R-Pod water Heater 1001 Posted: 25 Aug 2010 at 6:22pm |
hmmm. I think I can rule that out because it did actually fire up one time and the dealer says is worked on check out. I guess I am in for a warranty run to the nearest dealer that will service. Thanks.
|
|
vandallc
2011 177 2003 Lincoln Navigator |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 24 Aug 2010 at 4:56pm |
The documentation is almost worthless, yes. A shot in the dark - on my popup there was a valve where the water heater connected to the gas line. I don't know if they have one on the 'pod but its worth a look.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
vandallc
Groupie Joined: 02 May 2010 Location: Charleston, SC Online Status: Offline Posts: 41 |
Posted: 24 Aug 2010 at 12:46pm |
Sorry apparently hit send before I was finished...
Insured that water was in the tank and the water and tank were both cooled down from heating the water using electric.
When I flip the switch (inside the pod) the ignition attempts three times as expected but no ignition occurs and I see no evidence that gas is coming from the vent.
Any thoughts will be greatly appreciated.
Generally still pretty happy with the pod but boy the documentation is poor and disjointed.
|
|
vandallc
2011 177 2003 Lincoln Navigator |
|
vandallc
Groupie Joined: 02 May 2010 Location: Charleston, SC Online Status: Offline Posts: 41 |
Posted: 24 Aug 2010 at 12:43pm |
I have been unable to get the water heater to work on LP alone and will take it in to a dealer for warranty work but first wanted to see if anyone had suggestions as to what I might try trouble shooting wise before I make the trip to a dealer. Here is what I have and have tried.
2011 model 177
Insured that gas is adequate by testing the stove and using LP on the refrig which both worked.
Tried with the electric switch in the compartment near the gas jet in both the on and off position
|
|
vandallc
2011 177 2003 Lincoln Navigator |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 07 Jun 2010 at 10:54am |
Oh, and in case you didn't know you can use the electric mode and gas mode at the same time, for faster recovery times when you have full hookups. The gas thermostat trigger point is set slightly higher so the electric element will maintain the temperature most of the time, but when you jump in the shower the gas burner will kick on too.
When we have electric but no sewer I'll only turn on the electric mode since we only need hot water for washing hands and dishes. I don't like dealing with portable totes (like this) so we'll just use the bath house for showers.
And of course you can only use the gas mode in dry camp unless you run a generator. The electric element is one of the 3 things on the 'pod that can only run on 120 and not 12 volts. Doesn't make much sense to use a genset just for this since gas has a much faster recovery time than electric. The electric element doesn't add much to recovery when they are both on. But if you happen to have the genset running for something else and have the spare wattage available, it does help some.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
tort and hare
Newbie Joined: 03 Jun 2010 Location: Veneta, Oregon Online Status: Offline Posts: 7 |
Posted: 07 Jun 2010 at 12:05am |
I'm also learning where everything is on my 175 (2010 model). After searching for my hot water heater by-pass valves, I located them behind a small access panel in the rear storage area (left side). 4 small screws held it in. That being found, I could not see or feel them. I ended up crawling through the right side storage area door to see if they were even in there. They were, and in the Summer mode (by-pass valve closed). Possibly could also be accessed by removing mattress and plywood under it, however I didn't check this possibility.
|
|
Tortoise and the Hare
|
|
barbanjoe
Senior Member Joined: 21 Apr 2010 Location: Arizona Online Status: Offline Posts: 126 |
Posted: 06 Jun 2010 at 11:16pm |
I don't think we need to winterize, we moved from central pennsy to arizona 8 years ago and I usually wear shorts on xmas day, LOL
|
|
BarbanJoe
010 Rpod 171 02 Jeep 4x4 12 Ram 1500 |
|
barbanjoe
Senior Member Joined: 21 Apr 2010 Location: Arizona Online Status: Offline Posts: 126 |
Posted: 06 Jun 2010 at 11:11pm |
thanks much for the help I'll look next weekend , working doubles all week
|
|
BarbanJoe
010 Rpod 171 02 Jeep 4x4 12 Ram 1500 |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 06 Jun 2010 at 11:03pm |
You need to find the inside compartment where the water heater is located. On the 171 it is under the rear bed's mattress, to the right. There are 3 screws. The WH and pump are both there, nice for winterizing.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
barbanjoe
Senior Member Joined: 21 Apr 2010 Location: Arizona Online Status: Offline Posts: 126 |
Posted: 06 Jun 2010 at 10:24pm |
I have looked and only have the ac switch with the cotter pin in it . I even crawled under the pod and do not see the bypass valves, am I missing them? my pod is new feb 2010, and my water is hot only for short times and cools off.
|
|
BarbanJoe
010 Rpod 171 02 Jeep 4x4 12 Ram 1500 |
|
Post Reply | Page <1 3456> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |