U.S. Rpod Owners 2009-2010 models: PLEASE READ |
Post Reply | Page <1234 19> |
Author | |
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Post Options
Quote Reply
Topic: U.S. Rpod Owners 2009-2010 models: PLEASE READ Posted: 24 Jan 2013 at 8:32am |
I'll finally be getting this done soon. The Winter Campout will take me about 10 minutes from my dealer on the way home (when its usually 1 1/2 hours from my house) so I would be an idiot to not drop it off. Since they are already running wires up there I'm going to have them add a 3rd brake light just below the light bar. I think the low-mounted brake lights and lack of one higher up is a much more serious issue than adding the 3 little orange running lights up there. I'll probably just have them use an extra red marker light like the ones that will go on the fenders. Finally I've put so many miles on the pod the wheel bearings need a lube before we go anywhere this summer so I might as well have them do that too.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
dsmiths
Senior Member Joined: 10 Oct 2011 Location: Southern Ind Online Status: Offline Posts: 866 |
Post Options Quote Reply Posted: 19 Oct 2012 at 3:30pm |
Your right Sean, I was worried they would poke a hole in the skin and then if improperly sealed water gets in, rot aaaahhh. they did a great job, it really worked out great due to the fact they run the wiring up the passengers (right) side under the half tube trim. This was perfect because this spring we had a nasty hail storm, some stones were as big as a lemon and one knocked a hole in the tube trim about 1/2 the way down the back, short term I split some foam backer rod in half, pushed that in the hole with about 1 inch overlap on both sides of the hole and then filled and smoothed white silcone. They replaced it as part of the recall so everything worked out right. They did a nice job of caulking the seam, tucking the wiring in, it looks factory, the only thing I will correct is they use self tapping screws to mount the fender lights and they stick inside the wheel well about 3/4 of an inch and are razor sharp, if you run your hand in there to wash the wheel well area it will lay your hand open. Thats an easy fix. Now we have a New looking Pod.
|
|
Dane and Donna Smith
2011 RP-172 2008 Chevrolet Trailblazer 4X4 lift kit prodigy wireless brake controller |
|
Seanl
Senior Member Joined: 19 Sep 2011 Location: Fredericton NB Online Status: Offline Posts: 633 |
Post Options Quote Reply Posted: 19 Oct 2012 at 12:19pm |
They run the wires under the plastic trim on the edge of the RPod they don't drill through the skin
|
|
Sean, 2011 Rpod RP-173,2009 Jeep Liberty Rocky Mountain Edition
|
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Post Options Quote Reply Posted: 19 Oct 2012 at 10:26am |
Luck!
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
dsmiths
Senior Member Joined: 10 Oct 2011 Location: Southern Ind Online Status: Offline Posts: 866 |
Post Options Quote Reply Posted: 18 Oct 2012 at 10:47pm |
I am picking up our 2011 RP-172 tomorrow after the rear light recall, I am going to check over the install with a fine tooth comb. I want to make sure there is a good seal between the spoiler and the body of the pod so water wont collect and find a way in through where they drilled (ouch) the skin to run the wires. anyway wish me luck.
|
|
Dane and Donna Smith
2011 RP-172 2008 Chevrolet Trailblazer 4X4 lift kit prodigy wireless brake controller |
|
dsmiths
Senior Member Joined: 10 Oct 2011 Location: Southern Ind Online Status: Offline Posts: 866 |
Post Options Quote Reply Posted: 11 Oct 2012 at 7:42pm |
Tidal Wave, thanks for the tip, I have an appointment this upcoming thursday , I will mention this to them, we have the R-Dome but have not had the opportunity to use it yet, but I know we will.
|
|
Dane and Donna Smith
2011 RP-172 2008 Chevrolet Trailblazer 4X4 lift kit prodigy wireless brake controller |
|
Paige
podders Helping podders - pHp Joined: 23 Jul 2012 Location: Upstate NY Online Status: Offline Posts: 216 |
Post Options Quote Reply Posted: 11 Oct 2012 at 6:38pm |
Got our lights on today. We had to get the authorization letter from Susan because we are the second owners of our RPod. Our dealer was great. They ordered the lighting kit as soon as they got the letter that I faxed to them. It took under two weeks for the whole process.
|
|
Paige and Pete
2010 177 - RPug 2012 Rav (six cylinder) New York & Florida residents |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Post Options Quote Reply Posted: 09 Aug 2012 at 8:00pm |
Good to know, thanks. |
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
TIDALWAVE
Senior Member Joined: 21 Nov 2009 Location: MINNESOTA Online Status: Offline Posts: 315 |
Post Options Quote Reply Posted: 09 Aug 2012 at 4:56pm |
If you have the R-Dome for your R-Pod...don't forget to mention it to the Recall Service tech. I didn't mention it to my tech and he said that they use a different routing in the wheel well to miss the Dome's skirt. A lot easier and faster to install, if you don't have the Dome. No angled body drilling to route the wires into the well.
|
|
TIDALWAVE
|
|
TerryM
Admin Group - pHp Joined: 16 Nov 2009 Location: Saint Augustine Online Status: Offline Posts: 1950 |
Post Options Quote Reply Posted: 08 Aug 2012 at 2:32pm |
That is the same exact letter I got. But, I didn't make mine public for all the world to see. Terry |
|
RP-175 W/Lift Kit 2011 Ford F-150 4X4
Saint Augustine, FL: The first permanent European settlement in the USA: 1565 |
|
Post Reply | Page <1234 19> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |