Dinette screws in 180

Nice colour match, the screws look like they belong.

I had to do similar work on the door side dinette seat as well.

I needed to redo the floor screws, as the ones they put in were screwed into holes in the floor that were too large.

As well I needed to add L shaped brackets to reinforce the horizontal wood structure inside the seat at all the accessible corners, top and bottom.

Now we can use the seat without it wobbling.

I still need to replace the plastic mounts for the steel tubes that the table sits on. Junk light weight plastic.

Have a good one,

Andy

If screwing into the light wood pieces, I would recommend marking and pre-drilling the holes to prevent them from splitting when the wood screws are installed.

There are a lot of Red Green fans out there, which is great! I think we can all use a bit more humour in our day.

Andy