steps?

Has anyone found a way to change the steps or add some kind of steps/ramp to make it easier for people with disabilities?

I have double steps, I had to elongate two hole in steps, easy peezy and install was less than 1/2 hour.

After 7 years of owning our 177 I finally installed the 4" lift kit to get the pod higher off the ground.  The result was that the single step was no longer useful or safe so we went with the Stromberg-Carlson double step.  Cost was $ 95.81 and took me about 1.5 hours to take old one off and then cut a couple pieces out of the new step as well as drill a couple holes in each side so that it would function properly.  Just measured the rise in inches per step and it came out to step 1 - 7", step 2 - 7", and step 3 - 8".

I was wondering if anyone has had this issue.  I purchased and installed a set o Flexco steps.  With 2 steps and the 8 inch drop they were perfect.  That is until the sides of the bottom step began sliding behind the protruding tab on the frame that is supposed to hold the bottom step horizontal.  Now the bottom step sits at a 45 degree angle and is useless.  It's as if the frame has bent.  Etrailer has offered to replace them under warranty if I send them back.  That's fine except I drilled holes to make them fit.

one thing to watch is on the newer HRE that comes with the double step.  One nut came off and the other one loosened itself even with a lock washer.  I used blue lock tight on the bolts and hopefully it will hold the nuts on.