Author |
Share Topic Topic Search Topic Options
|
1016
Newbie
Joined: 28 May 2018
Location: Granbury
Online Status: Offline
Posts: 29
|
Topic: Hot water heater Posted: 19 Jun 2018 at 8:27pm |
how do I light the hot water heater. When I turn the switch on inside the camper the red light comes on and stays on
|
|
Tars Tarkas
Senior Member
Joined: 14 Jan 2013
Location: Near Nashville
Online Status: Offline
Posts: 1450
|
Posted: 19 Jun 2018 at 8:40pm |
You're doing right. Is the propane on? Can you light the stove? If so, give the WH a while to try to light itself. There could be air in the line that will take several lighting attempts to purge.
Do you know you have water in the WH tank?
TT
|
2010 176
FJ Cruiser
|
|
Kup-Pod
Senior Member
Joined: 08 Jun 2017
Location: Guelph, Ontario
Online Status: Offline
Posts: 153
|
Posted: 19 Jun 2018 at 9:07pm |
+1 to Tars Tarkas... I usually take the time to light the stove first to get most of the air out of the line first since it takes a while before it's all purged out. When running the water heater on propane you should be able to hear the burner going as it heats.
|
2017 RP-178
2021 F150 5.0l
"Lead me on a level path"
|
|
1016
Newbie
Joined: 28 May 2018
Location: Granbury
Online Status: Offline
Posts: 29
|
Posted: 19 Jun 2018 at 9:20pm |
I think I figured it out. It was on electric and I wasn’t turning the switch off on the outside switch when I was trying to run it on propane. When we bought it I wasn’t told about the inside and outside switches. So to run on electric inside switch off outside switch on and just opposite to run on propane. Sound right?
|
|
CharlieM
Senior Member
Joined: 23 Nov 2012
Location: N. Colorado
Online Status: Offline
Posts: 1797
|
Posted: 19 Jun 2018 at 10:01pm |
To run on gas the inside switch must be on. The red light should come on briefly and go out when the burner lights. To run on electric the outside switch must be on and the Pod plugged in to shore power. However, the two modes are completely independent. There is no interaction. You can run on gas and electric simultaneously, which will heat water almost twice as fast. If the gas switch is on and propane is present it will run regardless of the electric switch, and vice versa. If the electric is on and powered but propane is absent the red light will stay but the electric element will still heat. If both electricity and propane are present both heaters will operate until temperature is reached, after which the electric element will maintain the temp by itself.
|
Charlie
Northern Colorado
OLD: 2013 RP-172, 2010 Honda Pilot 3.5L 4WD
PRESENT: 2014 Camplite 21RBS, 2013 Supercharged Tacoma 4L V6 4WD
|
|
Podizzi
Newbie
Joined: 30 Jun 2017
Location: Phoenix, AZ
Online Status: Offline
Posts: 39
|
Posted: 19 Jun 2018 at 10:20pm |
Where is the switch located to turn electric on? I have a 179.
|
Podizzi
2017 rpod 179
2016 Toyota Sequoia
Phoenix, AZ
|
|
Tars Tarkas
Senior Member
Joined: 14 Jan 2013
Location: Near Nashville
Online Status: Offline
Posts: 1450
|
Posted: 20 Jun 2018 at 7:26am |
The switch is on the outside of the WH, probably almost hidden under a tube, in the bottom left, as I recall. It may have a cotterkey through it to prevent it from being switched by mistake. Be sure you have water in the tank before turning it on.
TT
|
2010 176
FJ Cruiser
|
|
1016
Newbie
Joined: 28 May 2018
Location: Granbury
Online Status: Offline
Posts: 29
|
Posted: 20 Jun 2018 at 7:27am |
Thanks a lot. He had me puzzled
|
|