Generator

How much was the discount with the FORESTRIVER code?  

Are the installation instructions pretty clear? 

Thanks in advance.

I got the discount code direct from Micro-Air's customer support when I called. Before you check out, there will be a place to enter the discount code. I don't remember though if it was before entering the credit card data, but it was before the final purchase approval. The discount was $40.00.

The instructions that come in the box are pretty generic. However, go on their site and download the more detailed Penguin II instructions. They are quite clear. I did not purchase the installation kit so what I did was slightly different. I re-used the strain relief, adding the wires for the Easy Start. It was a bit tricky as it was a very tight fit to get the strain relief back in place with the additional wires. Also, I left the PTC and start capacitor in place after disconnecting the wires. I just wrapped the loose ends up and used a wire tie to get and keep them out of the way. If you don't already have a tool for cutting wires and crimping terminals, you will need one. They aren't expensive. The Easy Start wires do not have terminals pre-attached so you will need the tool regardless of whether you buy the installation kit or not.