Generator

I got the discount code direct from Micro-Air's customer support when I called. Before you check out, there will be a place to enter the discount code. I don't remember though if it was before entering the credit card data, but it was before the final purchase approval. The discount was $40.00.

The instructions that come in the box are pretty generic. However, go on their site and download the more detailed Penguin II instructions. They are quite clear. I did not purchase the installation kit so what I did was slightly different. I re-used the strain relief, adding the wires for the Easy Start. It was a bit tricky as it was a very tight fit to get the strain relief back in place with the additional wires. Also, I left the PTC and start capacitor in place after disconnecting the wires. I just wrapped the loose ends up and used a wire tie to get and keep them out of the way. If you don't already have a tool for cutting wires and crimping terminals, you will need one. They aren't expensive. The Easy Start wires do not have terminals pre-attached so you will need the tool regardless of whether you buy the installation kit or not.

How much was the discount with the FORESTRIVER code?  

Are the installation instructions pretty clear? 

Thanks in advance.

First impressions of the EasyStart:

Installation:

Not difficult. The hardest part is re-using the strain relief if you don't purchase the installation kit. I didn't since I had a good assortment of connectors and proper guage wire. I did go out and purchase heavy-duty flag style connectors though as I did not have any of those on hand (I thought I did, but didn't). The extras will go into my box for future use on other projects. The diagram that came with the EasyStart covered the wiring of different style systems. However, I went online and found a setup tutorial specific to the Penguin II model that is used on most, if not all, recent R-Pod models. I had to bend some copper tubing slightly to make just a bit more room, but that was not hard at all.

While I had it apart, I saw that one of the machine bolts for the fan motor was sitting in the bottom of the pan. I remedied that, putting it back where it belongs.

After completing the installation, I began the recommended five starts on shore power. Since the instructions say that there is an internal timer to prevent it from restarting within 5 minutes, I ran it until I could measure air coming out at about 60 degrees F, then cut it off. I did this with the fan speed on High.

Once the initial training was done, I started the Generac iX2000 and turned on the AC. The Generac dis speed up, but it did not have the same surge that it did without the EasyStart. It is running now and does not appear to be straining. I have it in Eco mode, and it still started the AC with no problem.

Evaluation:  I think this will be a good move. The proof will be when it gets hot or when we are at higher elevations. Today is cooler than it has been so it isn't a hard test today. When it starts pushing 100F again, then it will be a better test. In the meantime, I think the EasyStart is going to prove itself to be a worthwhile addition to the Dometic AC. It is a shame that Dometic does not build them with EasyStart circuitry in the first place.