R-pod Owners Forum Homepage

This site is free to use.
Donations benefit a non-profit Girls Softball organization

Forum Home Forum Home > R-pod Discussion Forums > Podmods, Maintenance, Tips and Tricks
  New Posts New Posts RSS Feed: Hot Water Heater ByPass
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Topic ClosedHot Water Heater ByPass
 Post Reply Post Reply Page  <12
Author
Message
  Share Topic Share Topic  Topic Search Topic Search  Topic Options Topic Options
furpod View Drop Down
Moderator Group - pHp
Moderator Group - pHp
Avatar

Joined: 25 Jul 2011
Location: Central KY
Online Status: Offline
Posts: 6128 		Direct Link To This Post Topic: Hot Water Heater ByPass
    Posted: 11 Jan 2016 at 12:00pm
Could have a one way on the "out" side of the WH..
Back to Top
CharlieM View Drop Down
Senior Member
Senior Member
Avatar

Joined: 23 Nov 2012
Location: N. Colorado
Online Status: Offline
Posts: 1797 		Direct Link To This Post Posted: 11 Jan 2016 at 12:27pm
Still can dump into the WH if it's been emptied. 
Charlie
Northern Colorado
OLD: 2013 RP-172, 2010 Honda Pilot 3.5L 4WD
PRESENT: 2014 Camplite 21RBS, 2013 Supercharged Tacoma 4L V6 4WD
Back to Top
furpod View Drop Down
Moderator Group - pHp
Moderator Group - pHp
Avatar

Joined: 25 Jul 2011
Location: Central KY
Online Status: Offline
Posts: 6128 		Direct Link To This Post Posted: 11 Jan 2016 at 1:54pm
If it bypasses the cold water fill side, then meets the T of the hot/exit side, and there is a one way between it and the tank, it will not fill.
Back to Top
CharlieM View Drop Down
Senior Member
Senior Member
Avatar

Joined: 23 Nov 2012
Location: N. Colorado
Online Status: Offline
Posts: 1797 		Direct Link To This Post Posted: 11 Jan 2016 at 2:04pm
Originally posted by furpod

If it bypasses the cold water fill side, then meets the T of the hot/exit side, and there is a one way between it and the tank, it will not fill.


Yes, but I'm not aware of a check valve in that outlet line. And if it is there that inhibits draining of the HW pipes and HW heater from the hot low point drain. All said I think the three valve setup, or two either/or valves, is best. Actually two either/or valves might be better since you would get either hot water, cold water, or no water, but not luke warm water.
Charlie
Northern Colorado
OLD: 2013 RP-172, 2010 Honda Pilot 3.5L 4WD
PRESENT: 2014 Camplite 21RBS, 2013 Supercharged Tacoma 4L V6 4WD
Back to Top
techntrek View Drop Down
Admin Group - pHp
Admin Group - pHp
Avatar

Joined: 29 Jul 2009
Location: MD
Online Status: Offline
Posts: 9062 		Direct Link To This Post Posted: 12 Jan 2016 at 9:31pm
At first I thought it must allow some antifreeze in, but it can't be much.  I used slightly less than a gallon in the pod, and slightly over a gallon in the Salem, which I expect since the plumbing system is a little bigger.  Last year I even tried to drain the WH again when I was done and didn't get anything out.
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
Back to Top
 Post Reply Post Reply Page  <12

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.64
Copyright ©2001-2009 Web Wiz