Author |
Share Topic Topic Search Topic Options
|
Jdub
Groupie
Joined: 17 Mar 2013
Online Status: Offline
Posts: 94
|
Topic: Heater needs shore power?? Posted: 25 Sep 2013 at 8:50am |
Hot water heater and stove and refrigerator were all working fine on propane.
I have to assume there is some kind of safety device that does block the firing of the heater when only running on somewhat drained 12 volt batteries (2013 178 with two batteries up front). Maybe we need a generator,
|
 |
Tars Tarkas
Senior Member
Joined: 14 Jan 2013
Location: Near Nashville
Online Status: Offline
Posts: 1454
|
Posted: 24 Sep 2013 at 10:34pm |
If this was the first time you fired up the furnace in a while it may be that the propane never made it to the pilot. Once the gas gets to the pilot it will probably light every time. One trick to get the propane going is to make sure the stove lights. Had you been using the hot water heater on propane?
Just guessing.
TT
|
2010 176
FJ Cruiser
|
 |
Jdub
Groupie
Joined: 17 Mar 2013
Online Status: Offline
Posts: 94
|
Posted: 24 Sep 2013 at 10:03pm |
Well ok. Just went outside and checked. Fully charged, no shore power, and the furnace kicked on just fine.
So what is a range here? The pod has to have 100% charge to fire the furnace? Not 75% or 50%? As usual the documents that come with the pod are completely worthless. This almost means that when dry camping we have to have the truck on charging the pod at the same time we are trying to fire the furnace.
Any thoughts?
|
 |
Jdub
Groupie
Joined: 17 Mar 2013
Online Status: Offline
Posts: 94
|
Posted: 24 Sep 2013 at 9:35pm |
We had plenty of juice, 50-75% based on the panel lights. There was just no ignition for the propane. When the pod was 44 degrees and I had set the thermostat for 85, I think it should have fired. It did fire in the driveway when it was 75 and the thermostat set for 85.
Sound like something is set wrong.....still in warranty.
|
 |
techntrek
Admin Group - pHp
Joined: 29 Jul 2009
Location: MD
Online Status: Offline
Posts: 9062
|
Posted: 24 Sep 2013 at 8:34pm |
Usually with low batteries the blower won't blow hard enough to trigger the vane switch, which keeps it from igniting. This is a safety feature to make sure the blower can move the heat out of the furnace. However, the blower will still blow until the battery is completely dead. I'm not sure why yours was turning off.
|
|
 |
Craneman
Senior Member
Joined: 12 May 2013
Location: Tokeland,wa
Online Status: Offline
Posts: 387
|
Posted: 24 Sep 2013 at 8:29pm |
Did you try again with the shore power unplugged at home?? Your batteries might have been low.
Moe
|
Jo and Gary, 2010-174,2011 F150
Jo and Gary
2010 174
2011 Ford 150
|
 |
Tars Tarkas
Senior Member
Joined: 14 Jan 2013
Location: Near Nashville
Online Status: Offline
Posts: 1454
|
Posted: 24 Sep 2013 at 8:26pm |
Sounds like the pod was warmer inside than you thought and maybe you didn't have the thermostat set high enough. Shore power is not necessary, but 12v is.
TT
|
2010 176
FJ Cruiser
|
 |
Jdub
Groupie
Joined: 17 Mar 2013
Online Status: Offline
Posts: 94
|
Posted: 24 Sep 2013 at 7:40pm |
Just got back from a four day cruise and, for the first time, woke up to a chilly pod...44 degrees. We were in a forest service camp so no shore power. I hit the heater and it just blew cold air for 20 seconds and turned off. No heat. But now back home I find plugged in the heater works great.
Really? You need shore power just to blow some propane heated hot air? This seems very dumb to me....
|
 |