R-pod Owners Forum Homepage

This site is free to use.
Donations benefit a non-profit Girls Softball organization

Forum Home Forum Home > R-pod Discussion Forums > Podmods, Maintenance, Tips and Tricks
  New Posts New Posts RSS Feed: trailer battery
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Topic Closedtrailer battery

 Post Reply Post Reply Page  12>
Author
Message
grizwalsh View Drop Down
Newbie
Newbie


Joined: 07 Apr 2018
Location: b.c
Online Status: Offline
Posts: 35
Direct Link To This Post Topic: trailer battery
    Posted: 07 May 2018 at 12:32pm
Hi---Can anyone tell me if it's usual for the battery (after being charged fully) to lose one third charge?.  I checked it today and the gauge in the trailer registered two thirds charge--there was nothing left on and when I put it on shore power it registered full charge
grizwalsh
Back to Top
texman View Drop Down
Senior Member
Senior Member
Avatar

Joined: 24 Jul 2014
Location: TeXas
Online Status: Offline
Posts: 446
Direct Link To This Post Posted: 07 May 2018 at 1:26pm
ignore the status lights in the trailer and check with a voltage meter.  Those lights are for show and not really accurate at all for voltage. The ones for the tanks are close in my pod, but others ignore them altogether. 
TexMan 2015 182g
2018 Sequoia
TexManMods
Back to Top
furpod View Drop Down
Moderator Group - pHp
Moderator Group - pHp
Avatar

Joined: 25 Jul 2011
Location: Central KY
Online Status: Offline
Posts: 6128
Direct Link To This Post Posted: 07 May 2018 at 1:38pm
"nothing left on in the trailer" is not attainable without removing the battery or adding a battery cut off switch.

The monitor shows "system voltage".. the instant you hook up to shore power, you will have "full charge" on the monitor, because the system voltage will be 13.2 to 14.4, the output of the converter. In fact, if you remove the battery from the system, the "battery monitor" will still show "full", if plugged into shore power.
Back to Top
StephenH View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 29 Nov 2015
Location: Wake Forest, NC
Online Status: Offline
Posts: 6329
Direct Link To This Post Posted: 07 May 2018 at 3:34pm
Look at the status light panel. There are two sets of labels. One is for checking the tanks. The other reflects state of charge. If you press the battery button while plugged in, all the lights will be lit. This indicates "Charging" not "Full." One less light still indicates the battery is at full charge, not 2/3 charge.
The lights are C(harge), G(ood), F(air), and L(ow). The  E(mpty), 1/3, 2/3, and F(ull) labels are for the tank status.

Otherwise, I agree that disconnecting the battery/batteries physically or using a cut-off switch is the only way to fully isolate them from the system and eliminate the parasitic power draws of the LP/CO detector and other equipment.
StephenH
Happy is the man that findeth wisdom,...

ouR escaPOD mods
Former RPod 179
Current Cherokee Grey Wolf 24 JS
Back to Top
grizwalsh View Drop Down
Newbie
Newbie


Joined: 07 Apr 2018
Location: b.c
Online Status: Offline
Posts: 35
Direct Link To This Post Posted: 07 May 2018 at 7:05pm
Thanks to all the replies on this topic--this forum sure helps out raw rv'ers like me--where would one install a battery cut off switch and if you're not tired of the subject yet--how does the process go?  
grizwalsh
Back to Top
StephenH View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 29 Nov 2015
Location: Wake Forest, NC
Online Status: Offline
Posts: 6329
Direct Link To This Post Posted: 07 May 2018 at 7:34pm
If you look in my mods, you will see how I did it. I mounted it into the lid of one of my two battery boxes. I have dual 6V batteries, so that worked for me.
StephenH
Happy is the man that findeth wisdom,...

ouR escaPOD mods
Former RPod 179
Current Cherokee Grey Wolf 24 JS
Back to Top
grizwalsh View Drop Down
Newbie
Newbie


Joined: 07 Apr 2018
Location: b.c
Online Status: Offline
Posts: 35
Direct Link To This Post Posted: 08 May 2018 at 8:06am
Thank you  
grizwalsh
Back to Top
Bailey View Drop Down
Newbie
Newbie


Joined: 08 May 2018
Online Status: Offline
Posts: 10
Direct Link To This Post Posted: 09 May 2018 at 10:12am
I just got a new rpod. First trip comin up. Wonder about using white hose to fill potable tank. Also is there a hose to drain drinking water tank? Thx. Bailey
Back to Top
texman View Drop Down
Senior Member
Senior Member
Avatar

Joined: 24 Jul 2014
Location: TeXas
Online Status: Offline
Posts: 446
Direct Link To This Post Posted: 09 May 2018 at 10:31am
bailey

fresh water drain is underneath on the tank.  yes, use a hose suitable for drinking water, which are usually white, but blue as well.  just check the label for potable water use.
TexMan 2015 182g
2018 Sequoia
TexManMods
Back to Top
Bailey View Drop Down
Newbie
Newbie


Joined: 08 May 2018
Online Status: Offline
Posts: 10
Direct Link To This Post Posted: 09 May 2018 at 10:46am
What do podders do if wish to drain drink water tank in cmpgrnd or lublic.
Back to Top
 Post Reply Post Reply Page  12>

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.64
Copyright ©2001-2009 Web Wiz