R-pod Owners Forum : Adding Outrigger Supports http://www.rpod-owners.com/ This is an XML content feed of; R-pod Owners Forum : I need HELP!!! : Adding Outrigger Supports Copyright (c) 2006-2009 Web Wiz Forums - All Rights Reserved. Thu, 21 May 2026 01:10:44 +0000 Mon, 10 Jul 2023 12:19:09 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 9.64 360 www.rpod-owners.com/RSS_post_feed.asp?TID=15771 R-pod Owners Forum http://www.rpod-owners.com/forum_images/web_wiz_forums.png http://www.rpod-owners.com/ Adding Outrigger Supports : It is sagging. I have approx.... http://www.rpod-owners.com/forum_posts.asp?TID=15771&PID=152265#152265 Author: Dhammel
Subject: 15771
Posted: 10 Jul 2023 at 12:19pm

It is sagging.  I have approx. 1in+ out of square on the distance from the frame to the outside of the wall.  The slider still works fine - but there is sag.
]]> Mon, 10 Jul 2023 12:19:09 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15771&PID=152265#152265 Adding Outrigger Supports : If it's not sagging, there... http://www.rpod-owners.com/forum_posts.asp?TID=15771&PID=152263#152263 Author: GlueGuy
Subject: 15771
Posted: 10 Jul 2023 at 9:59am

If it's not sagging, there is probably no need to jack it up. You should check the level of the floor for each outrigger and jack up if necessary. If top of the outrigger is not flush or parallel, then jacking will probably be needed.]]> Mon, 10 Jul 2023 09:59:07 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15771&PID=152263#152263 Adding Outrigger Supports : I have the typical floor / frame... http://www.rpod-owners.com/forum_posts.asp?TID=15771&PID=152261#152261 Author: Dhammel
Subject: 15771
Posted: 10 Jul 2023 at 8:46am

I have the typical floor / frame issue on the slide out side.  I've watched the You Tube videos and read the Forum posts - but my question is shouldn't the wall be jacked up simultaneously at the two locations where the inner aluminum frame wall supports (studs) are located on either side of the slide out?  

I've seen others jack from other points but doesn't that run the risk of distorting the inner frame?






]]> Mon, 10 Jul 2023 08:46:07 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15771&PID=152261#152261