http://www.rpod-owners.com/ This is an XML content feed of; R-pod Owners Forum : I need HELP!!! : Solar not charging and battery depletion Copyright (c) 2006-2009 Web Wiz Forums - All Rights Reserved. Thu, 21 May 2026 03:31:01 +0000 Sun, 28 Aug 2022 16:25:12 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 9.64 360 www.rpod-owners.com/RSS_post_feed.asp?TID=15446 http://www.rpod-owners.com/forum_images/web_wiz_forums.png http://www.rpod-owners.com/ http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149481#149481 Author: Gregs Pod
Subject: 15446
Posted: 28 Aug 2022 at 4:25pm

Thank you, I'll take a look at those]]> Sun, 28 Aug 2022 16:25:12 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149481#149481 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149479#149479 Author: Gregs Pod
Subject: 15446
Posted: 28 Aug 2022 at 4:24pm

Thanks Off Grid. Tech did not test under load just at wires disconnected from through roof plate as indicated by Go Power. Controller was just replaced but same GoPower model....I have spare 12 v batteries from our off grid cabin and boats so that may be my next step without having to remove the trailer batteries...]]> Sun, 28 Aug 2022 16:24:12 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149479#149479 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149478#149478 Author: StephenH
Subject: 15446
Posted: 28 Aug 2022 at 4:18pm

Another alternative is to ditch the MC connectors and use PowerPole connectors. That is what I did. The PowerPole connectors are much easier to disconnect and connect, and can be done repeatedly without special tools.]]> Sun, 28 Aug 2022 16:18:40 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149478#149478 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149477#149477 Author: offgrid
Subject: 15446
Posted: 28 Aug 2022 at 4:13pm

How did the tech test the solar modules? You can't just check the open circuit voltage and the short circuit current of a solar module and call it good. If your having a problem then you should place the module(s) under load.

To do that you can connect the solar modules directly to a 12V battery without the controller. This wont harm the battery by overcharging it if you only do it for a short time


You'll probably have to buy a sect of MC connectors so you can connect the modules to the battery.

Once connected, on a clear sunny day record the battery voltage and the charging current. The current should be in the range of 4 or 5 amps or so from each module and 8 to 10A from the two modules combined in parallel.

If you get that then the modules are good and you can focus on wiring or controller issues. ]]> Sun, 28 Aug 2022 16:13:28 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149477#149477 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149472#149472 Author: Gregs Pod
Subject: 15446
Posted: 28 Aug 2022 at 1:16pm

I have a 2019 rpod 191 that was pre-wired for solar. Had the dealer install GoPower 220 flex panel kit that comes with GP30 controller. It has never worked right. now batteries discharge daily. GoPower replaced controller under warranty but charging amps still below 1, even in full sun with boost. Dealer rewired as wrong gage extensions had been used. Field tech has tested panel output and its fine. Any suggestions appreciated.]]> Sun, 28 Aug 2022 13:16:51 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=15446&PID=149472#149472