http://www.rpod-owners.com/ This is an XML content feed of; R-pod Owners Forum : I need HELP!!! : Water heater wiring problem Copyright (c) 2006-2009 Web Wiz Forums - All Rights Reserved. Wed, 20 May 2026 17:05:08 +0000 Wed, 30 Oct 2019 20:13:42 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 9.64 360 www.rpod-owners.com/RSS_post_feed.asp?TID=13258 http://www.rpod-owners.com/forum_images/web_wiz_forums.png http://www.rpod-owners.com/ http://www.rpod-owners.com/forum_posts.asp?TID=13258&PID=127940#127940 Author: Badweissenbier
Subject: 13258
Posted: 30 Oct 2019 at 8:13pm

Hello all, so I ran into a problem. I pulled the bed on my 190 to winterize. Once I have the boards up I find that the blue wire coming from the spark/ignite box for the water heater is laying there unhooked to anything. It has the end stripped like it was connected at some point. I then find every crimp connection is loose. So I replace every one and confirm I now have solid tight crimps.
There is a 16/18 gauge ribbon with red grey and white wires coming in with the grey wire not hooked to anything, it does have a crimp connector on the end. Tracing it I find it goes to the board on the tank monitor , it changes wires to a small pink one to make that connection at the final terminal on the board. Is this grey wire supposed to be connected to the blue wire on the igniter box?
If someone could check theirs and confirm I’d really appreciate it

Thank you ]]> Wed, 30 Oct 2019 20:13:42 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=13258&PID=127940#127940