http://www.rpod-owners.com/ This is an XML content feed of; R-pod Owners Forum : I need HELP!!! : water pump setting Copyright (c) 2006-2009 Web Wiz Forums - All Rights Reserved. Thu, 21 May 2026 04:37:11 +0000 Wed, 12 Jun 2019 13:21:43 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 9.64 360 www.rpod-owners.com/RSS_post_feed.asp?TID=12933 http://www.rpod-owners.com/forum_images/web_wiz_forums.png http://www.rpod-owners.com/ http://www.rpod-owners.com/forum_posts.asp?TID=12933&PID=124770#124770 Author: VTKeen
Subject: 12933
Posted: 12 Jun 2019 at 1:21pm

Thank you offgrid. I reset that line as you suggested and still no luck. Then it occurred to me the other 2 lines into the hot water tank were on bypass. When I changed them back the water flowed into the tank. The lines are not set up in the direction one would think is correct but know I understand my water valve set up. Great forum.

]]> Wed, 12 Jun 2019 13:21:43 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12933&PID=124770#124770 http://www.rpod-owners.com/forum_posts.asp?TID=12933&PID=124769#124769 Author: offgrid
Subject: 12933
Posted: 12 Jun 2019 at 11:49am

The short line with the open end is for drawing in antifreeze while winterizing. Normally the valve should be set to pull off the water tank and not that line. The position of the valve in your photo will not allow the pump to draw water from the tank. Turn it the other way, fill your water tank, and see if that fixes your problem. 

]]> Wed, 12 Jun 2019 11:49:36 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12933&PID=124769#124769 http://www.rpod-owners.com/forum_posts.asp?TID=12933&PID=124761#124761 Author: VTKeen
Subject: 12933
Posted: 12 Jun 2019 at 10:30am

We are in the process of de-winterizing. When we pulled the anode out to inspect I expected our bleach solution water to run out of the hot water tank. Instead it was just wet. I have the hot and cold water lines in the on position and they ran everywhere else just fine. I wonder: there is a valve coming off the water pump that I also moved in a parallel to the line position. Could that be the problem with hot water tank not filling up? That valve has another line that is short line like an overflow. I moved it back where it was prior to de-winterizing in this photo: Suggestions? Is this the issue with hit water tank not filling up?

]]> Wed, 12 Jun 2019 10:30:52 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12933&PID=124761#124761