http://www.rpod-owners.com/ This is an XML content feed of; R-pod Owners Forum : Podmods, Maintenance, Tips and Tricks : '17 179 slide out IS dimension Copyright (c) 2006-2009 Web Wiz Forums - All Rights Reserved. Wed, 29 Apr 2026 22:37:27 +0000 Sat, 19 Jan 2019 21:59:30 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 9.64 360 www.rpod-owners.com/RSS_post_feed.asp?TID=12548 http://www.rpod-owners.com/forum_images/web_wiz_forums.png http://www.rpod-owners.com/ http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119772#119772 Author: StephenH
Subject: 12548
Posted: 19 Jan 2019 at 9:59pm

It comes in handy that our RPod sits in our driveway. It makes it very convenient to run out and take a measurement. ]]> Sat, 19 Jan 2019 21:59:30 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119772#119772 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119771#119771 Author: SteveA
Subject: 12548
Posted: 19 Jan 2019 at 9:45pm

Thanks Steven (I had a feeling it would be you to come to my rescue).  I am very familiar with your mods and have learned a ton over the last few years. Appreciated :) ]]> Sat, 19 Jan 2019 21:45:38 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119771#119771 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119767#119767 Author: StephenH
Subject: 12548
Posted: 19 Jan 2019 at 9:12pm

The length of the from front to back is 75-1/2" (minus an eighth if you look at the molding strip). It fits a 75" mattress length just fine. I did a conversion (see my mods, link in signature) to remove the curved cushions and make two full length cushions and also converted the table to a two-pedestal table with a board that slides out to support the cushions at the same level as the floor of the slide-out. It makes a 3/4 width bed (75"x45") and there are sheet sets available to fit.
]]> Sat, 19 Jan 2019 21:12:00 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119767#119767 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119764#119764 Author: SteveA
Subject: 12548
Posted: 19 Jan 2019 at 7:39pm

Hello, I have a '17 1/2 179 and I'm seriously thinking about going the Futon route. I'm in AZ for the winter and the Pod is in Idaho so I can't measure myself so as to start doing some homework. If a tape is handy and not a pain in rear could someone measure the inside width dimension of the slide? Thanks a bunch in advance. ]]> Sat, 19 Jan 2019 19:39:36 +0000 http://www.rpod-owners.com/forum_posts.asp?TID=12548&PID=119764#119764