Last edited 11/15/2011. Re-ordered some steps and cleaned it up.
1) Make sure the black and gray waste water tanks are empty.
2) Outside and underneath the trailer, unscrew your fresh water tank's drain and allow it to empty.
3) Turn on the water pump and open a valve to suck up any remaining water in the line between the tank and the pump.
4) Open both low-point drains underneath the camper.
5)
Attach a "blow-out plug" to the city water connection. This has an air
inlet on one end like the valve stems on your tires, and threads to
attach to the water connection. Apply LOW pressure air (less than 20
psi) for several seconds. Any RV dealer should have one of these plugs.
6) Remove the blow-out plug.
7)
Outside, remove the plug on the hot water heater to check the anode rod
and replace if necessary (about every two years). The water heater must
be stored dry - do not try to fill it with antifreeze. Wait for the
water to stop running out of the drains and plug hole. Using a garden
hose, flush any debris from inside the water heater tank. If
you don't need to inspect your anode rod you can pull open the pressure
relief valve at the top of the heater to speed up the draining process,
it will still take a while. While the tank is draining go inside and open up every valve so suction will pull water out of every line and faucet.
8) Wrap the threads of the anode rod with Teflon tape, re-insert the plug and close both low-point drains.
9) Re-insert the fresh water tank plug while you are outside.
10) Turn the bypass valves on the hot water heater. The valves are inside the trailer - mine are under the bed on the road side.
11)
On the intake line for the water pump, you'll notice a valve and about 2
1/2' of tubing that's loose on one end. Flip the valve and put the
loose end into your jug of RV antifreeze (DO NOT USE AUTO ANTIFREEZE).
The pump will now draw from the jug of antifreeze instead of your fresh
water tank.
12) Turn on the switch for the water pump for a few seconds, then turn it off. Your low-point drains should still be open, go outside and verify they are dripping pink. You may need to cycle the pump a few more seconds to be sure. Then close both low-point drains.
13) Turn on the taps at the sink and in the shower, one at a time. Let each run until the water is pink.
14) Run the toilet until the water is pink. Leave some pink stuff in the bottom of the toilet to keep the drain valve from drying out over the winter.
15)
Pull the hose out of the antifreeze bottle just enough so it can't suck
up any more antifreeze. Turn on the sink again for a second or two
until the antifreeze is out of the intake line. This keeps the sticky
antifreeze from running all over the floor when you pull the intake
completely out of the bottle.
16) Close the valve near the water pump, stow the intake hose and close the access panel, turn off the power for the water pump.
17) Pour some RV antifreeze down the shower and sink drains.
18)
Set the fridge's door latch so it stays open - look at the assembly on
the wall of the fridge, you can slide it out some so when the door is
latched it stays open enough to prevent mold from growing.