Print Page | Close Window

Zamp port for supplying power from the battery?

Printed From: R-pod Owners Forum
Category: R-pod Discussion Forums
Forum Name: Podmods, Maintenance, Tips and Tricks
Forum Discription: Ask maintenance questions, share your podmods (modifications) and helpful tips
URL: http://www.rpod-owners.com/forum_posts.asp?TID=14073
Printed Date: 21 Jun 2025 at 11:59pm
Software Version: Web Wiz Forums 9.64 - http://www.webwizforums.com


Topic: Zamp port for supplying power from the battery?
Posted By: TheBum
Subject: Zamp port for supplying power from the battery?
Date Posted: 30 Sep 2020 at 5:59pm
Is the Zamp port connected directly to the battery without any diodes or such inline? If so, I'm thinking about using it to power a wireless backup camera since it's close to where the camera would be mounted, it's always on (as opposed to using the power for the running lights), it's easy to disconnect, and it doesn't involve piercing the Pod's shell beyond the camera mounting holes. I'd just have to figure out how to secure the wires.

-------------
Alan
2022 R-Pod 196 "RaptoRPod"
2022 Ram 1500 Lone Star 4x4
Three cats



Replies:
Posted By: GlueGuy
Date Posted: 30 Sep 2020 at 6:32pm
AFAIK, it should be. There might be an inline fuse, but I don't know about that. Easy enough to check.

-------------
bp
2017 R-Pod 179 Hood River
2015 Ford F150 SuperCrew 4WD 3.5L Ecoboost


Posted By: JR
Date Posted: 30 Sep 2020 at 7:54pm
I have a 2019 179 and the wiring from the rear of the trailer Zamp outlet had a positive wire running to the battery positive and the negative side was wired from the Zamp outlet to the frame in the rear (behind the wheel) then the negative was wired from the frame up by the right front frame (under the trailer) to the negative side of the battery with no fuse or circuit breaker in line on either the positive or negative line.  Hope this helps.

-------------
Jay

179/2019


Posted By: voisj
Date Posted: 30 Sep 2020 at 8:16pm
I use mine as a power port for a metal porch light that I stick to the magnet on the storage door.
My wires both run directly to the battery there's no fuse on it, so I added a fuse to the wires just inside the storage door behind a small panel next to the tail light, (on a 180).

-------------
http://www.rpod-owners.com/forum_posts.asp?TID=9426&title=slopod-180-mods-johnsue - SLOPODMODS
John&Sue,SLO,CA
2016 180 HRE, 2013 F150 Eco Boost
 


Posted By: Colt
Date Posted: 01 Oct 2020 at 1:03am
Not sure about a fuse, but my Zamp connector is hot all the time.

-------------
John
'16 R-Pod 180


Posted By: offgrid
Date Posted: 01 Oct 2020 at 7:23am
The zamp ports are hot all the time, you can use them to run loads no problem. Please add a fuse at the battery. 

Don't add the fuse at the load device. Fuses are intended to protect the wiring, they can't do that if you put them at the far end away from the source of power. It would be like taking all the circuit breakers out of your home panel and putting them in the receptacles instead. Not a good idea. Cry


-------------
1994 Chinook Concourse
1995 RV6A Experimental Aircraft
2015 Rpod 179 - sold


Posted By: podwerkz
Date Posted: 01 Oct 2020 at 11:06am
Originally posted by offgrid

 It would be like taking all the circuit breakers out of your home panel and putting them in the receptacles instead. Not a good idea. Cry

You mean I need to move them all back to the panel? Dang...two weeks of hard work...wasted...

Confused


-------------
r・pod 171 gone but not forgotten!


Posted By: TheBum
Date Posted: 01 Oct 2020 at 1:31pm
Wow, I didn't expect such a big response. Thanks for all the input. Now I just need to find a cable to plug into the Zamp port and wire into the camera.

EDIT: I found this one on Amazon that has plenty of cable and is reasonably priced. Think it'd work?

https://www.amazon.com/POWISER-Extension-Disconnect-Connector-Automotive/dp/B07Z7T494M/ - https://www.amazon.com/POWISER-Extension-Disconnect-Connector-Automotive/dp/B07Z7T494M/


-------------
Alan
2022 R-Pod 196 "RaptoRPod"
2022 Ram 1500 Lone Star 4x4
Three cats


Posted By: mcarter
Date Posted: 01 Oct 2020 at 5:41pm
My ZAmp is hot all the time, no fuse when connected to battery. I used it with fuse to mount a reel out service light that goes all around trailer in emergency situations. The service light is mounted inside the storage door.

-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."


Posted By: offgrid
Date Posted: 01 Oct 2020 at 6:16pm
Originally posted by podwerkz

Originally posted by offgrid

 It would be like taking all the circuit breakers out of your home panel and putting them in the receptacles instead. Not a good idea. Cry

You mean I need to move them all back to the panel? Dang...two weeks of hard work...wasted...

Confused
LOL

-------------
1994 Chinook Concourse
1995 RV6A Experimental Aircraft
2015 Rpod 179 - sold



Print Page | Close Window

Bulletin Board Software by Web Wiz Forums® version 9.64 - http://www.webwizforums.com
Copyright ©2001-2009 Web Wiz - http://www.webwizguide.com