I need HELP!!!: Removal of LED Running light???

Print Page | Close Window

Removal of LED Running light???

Printed From: R-pod Owners Forum
Category: R-pod Discussion Forums
Forum Name: I need HELP!!!
Forum Discription: Perplexed/need help with a problem - ask here
URL: http://www.rpod-owners.com/forum_posts.asp?TID=13544
Printed Date: 14 May 2025 at 8:09pm
Software Version: Web Wiz Forums 9.64 - http://www.webwizforums.com

Topic: Removal of LED Running light???

Posted By: MTNewbie20
Subject: Removal of LED Running light???
Date Posted: 12 May 2020 at 3:18pm

Hi All, have been searching the site for how to remove a back running light in order to install a back up camera. Just need access to the wires there. Does the light screw on/off, pry off, what? Don't want to do any damage!

TIA!!

-------------
Chuck and Shari
2020 Rpod 192
2007 Toyota Sequoia

Replies:

Posted By: furpod
Date Posted: 12 May 2020 at 4:00pm

If you are talking about the ones at the top, in the spoiler, they pop out.

Posted By: MTNewbie20
Date Posted: 12 May 2020 at 4:11pm

Yes at the top but no spoiler.

-------------
Chuck and Shari
2020 Rpod 192
2007 Toyota Sequoia

Posted By: mjlrpod
Date Posted: 13 May 2020 at 7:53am

I had mine installed when I purchased it. I didn't actually see how he did it. The camera is installed about 2 inches above the center light. I don't know if he might have put a small hole under the camera area, and fished the wires out, or if he removed the light, sorry.

-------------
2017.5 Rp-172
2020 R-pod 195
2015 Frontier sv 4.0L 6cyl
I'll be rpodding

Posted By: mattb19us
Date Posted: 05 Jul 2020 at 6:28pm

Originally posted by MTNewbie20

Hi All, have been searching the site for how to remove a back running light in order to install a back up camera. Just need access to the wires there. Does the light screw on/off, pry off, what? Don't want to do any damage!

TIA!!

Wondering about the same. I have a 195 and going to be removing the center light and adding a Furrion Vision system tomorrow

Posted By: mcarter
Date Posted: 05 Jul 2020 at 6:32pm

Why not use the back up light wiring that is in the harness? Leave your lights alone.

-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."

Posted By: mattb19us
Date Posted: 05 Jul 2020 at 6:37pm

Which harness?

Posted By: mcarter
Date Posted: 05 Jul 2020 at 6:42pm

The main harness of the Pod. On the front left of the Pod look and see if you have yellow wires terminated. Those wires are connected to the seven way and are the back up light wires. I used them when I added back up lights to my Pod. I would use them to power a back up camera. Take an voltmeter and verify.

-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."

Posted By: mattb19us
Date Posted: 05 Jul 2020 at 6:46pm

Ah yeah I was trying to avoid running new wires. There's 12V running to the backup LED's and there's 5 across, so if I can tap into the middle one, that should be a good location. Just need to seal it up well afterwards.

Posted By: mcarter
Date Posted: 05 Jul 2020 at 6:47pm

ok

-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."

Posted By: crw8sr
Date Posted: 06 Jul 2020 at 7:04pm

I wired ours to the license plate light. The camera is always on when the lights are on. I always drive with the vehicle lights on.

-------------
Chuck & Lyn
Izzy, Morkie. RIP
Zoe Joy & Gracie, Yorkie
2018 R Pod 190
2019 Traverse

In moments of adversity;when life's a total wreck, I think of those worse off than me and really feel like heck.