CO/Propane Detector Alarm
Printed From: R-pod Owners Forum
Category: R-pod Discussion Forums
Forum Name: I need HELP!!!
Forum Discription: Perplexed/need help with a problem - ask here
URL: http://www.rpod-owners.com/forum_posts.asp?TID=11786
Printed Date: 11 May 2025 at 12:09am
Software Version: Web Wiz Forums 9.64 - http://www.webwizforums.com
Topic: CO/Propane Detector Alarm
Posted By: BH&MH
Subject: CO/Propane Detector Alarm
Date Posted: 25 Jun 2018 at 2:23pm
We took our 2018 Model 180 out for three nights last weekend starting with a fully charged battery. At the campground, we turned on the water heater (we thought it ran on gas), started the fridge on gas mode, and turned on the water pump. We tried the heater when it got cold that night, but apparently haven’t burned off all the oils & dust, so the smoke alarm went off and we turned the heater off.
The next morning, the battery indicator on the control panel said the battery was on “E”. I was surprised that the battery died so quickly. It lasted fine on our first two trips. We turned off all electrical devices to conserve power and connected the power cable to our tow vehicle, but the interior lights kept getting dimmer. Even running the engine in our tow vehicle didn’t seem to charge the battery enough to make a difference.
By our 3rd night, we had no interior lights at all. After we were asleep, the CO/propane detector went off. We hit the reset button, but it went off again. I shut the gas off, burned the gas left in the lines, and opened windows, but the detector kept going off. I finally disconnected the battery so we could get some sleep.
I’m hoping someone can answer my questions:
1. An ideas why the battery died so quickly this time?
2. Would the loss of power affect the CO/propane detector? (We’re pretty sure there was no CO or propane problems inside the trailer.
Thanks.
|
Replies:
Posted By: mcarter
Date Posted: 25 Jun 2018 at 2:30pm
Answers to both are yes.
The battery is not charging. The alarm is going off because battery is low. Concerns me you hooked TV to battery and no charge. You can put a battery charger on battery and see if you have 12V accessories. Also have you confirmed your TV does in fact charge the battery? You can check that with a DVM at your 7 pin connector on the TV.
-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
Posted By: BH&MH
Date Posted: 25 Jun 2018 at 2:36pm
|
Yes, the TV does charge the battery, at least when we're on the highway. After leaving the campground, we stopped after about 90 minutes into a 3-hour drive and the control panel showed the battery level at 2/3.
|
Posted By: john in idaho
Date Posted: 25 Jun 2018 at 2:41pm
|
Sounds like something is running on 12v that shouldn't be.Are you sure the HWH and refridge are not on 12v? Do you have a digital voltmeter?
|
Posted By: mcarter
Date Posted: 25 Jun 2018 at 2:42pm
OK, good news. So next issue is to figure out what is draining battery so quickly in your estimation. Any and all 12V uses to include fridge on gas (control board) could be culprit. The alarm is not the issue, it's reacting to low 12V.
-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
Posted By: BH&MH
Date Posted: 25 Jun 2018 at 2:45pm
No, I'm not sure what is running on 12V. The flame symbol was lit up on the fridge. It looks like my next step is to get a digital voltmeter and learn how and where to use it.
Thanks.
|
Posted By: mcarter
Date Posted: 25 Jun 2018 at 2:54pm
Good idea. That flame symbol is powered by 12V.
-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
Posted By: john in idaho
Date Posted: 25 Jun 2018 at 2:54pm
|
Amazon has this amazing book - 12 volt bible for boats. Also applies to RV's. You will be enlightened about 12v electricity. I installed a digital voltmeter on the wall by the factory one. At the touch of a button, I know fairly precisely where the battery is in its discharge cycle.
|
Posted By: mcarter
Date Posted: 25 Jun 2018 at 2:56pm
+1 to meter, I can see here I am at across all 3 stages of charge and discharge.
-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
Posted By: ronahue
Date Posted: 25 Jun 2018 at 3:18pm
|
Just a couple of notes: The hot HWH only use 12 volt for control only it is unlikely that is enough to kill your battery. To be sure your TV is charging your battery the battery gauge must show 4 lights when you push the button if the TV is hooked up and running. The 4 lights does not tell that the battery is charged it simply tells you that the system voltage is high enough to charge the battery. I have a gut feeling that your TV is not charging the battery but I have been wrong before. Good Luck.
-------------
Ron & Sharon
2015 R-Pod 179
2022 Nissan Frontier
No trees were harmed in the sending of this message but a billion electrons were really agitated
|
Posted By: TheBum
Date Posted: 25 Jun 2018 at 4:35pm
I agree with ronahue. The 4th LED, labeled "C", is the one that tells you the battery is charging. When not connected to the TV or shore power, the highest it should go is 3 LEDs.
You may also be misreading the indicators; the battery indicator has a different definition for the LEDs than the tank level indicators do. The battery is either L (low), F (fair), G (good), or C (charging).
-------------
Alan
2022 R-Pod 196 "RaptoRPod"
2022 Ram 1500 Lone Star 4x4
Three cats
|
Posted By: mcarter
Date Posted: 25 Jun 2018 at 4:43pm
Bum, All good but unreliable. Need an added gauge or a DVM.
-------------
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
|