Batteries not reaching 'charged' on Trimetric
Printed From: R-pod Owners Forum
Category: R-pod Discussion Forums
Forum Name: Podmods, Maintenance, Tips and Tricks
Forum Discription: Ask maintenance questions, share your podmods (modifications) and helpful tips
URL: http://www.rpod-owners.com/forum_posts.asp?TID=10350
Printed Date: 28 May 2024 at 11:13am
Software Version: Web Wiz Forums 9.64 - http://www.webwizforums.com
Topic: Batteries not reaching 'charged' on Trimetric
Posted By: D Plex
Subject: Batteries not reaching 'charged' on Trimetric
Date Posted: 17 Jul 2017 at 11:52am
Hi everyone -
I was able to install 2 new 6 volt batteries to our r-pod and update the Trimetric 2025 programming to reflect their AH rating, 'charged' point, etc, but I'm a little confused. The Trimetric manual said to program the voltage 'charged' point (P1) to 14.3, but my batteries have not gone beyond 13.2 (6.6 per battery with my volt reader). The trailer idiot light shows 'charged', but the Trimetric does not (its green light is supposed to flash when the batteries reach a 'charged' state, which in this case I understand to be 14.3 or higher). Am I missing something simple? Pressing reset on the Trimetric charge % only resets the number to 100%, so I'm wondering if that's somehow limiting the battery charge? Note that this was an issue with my previous batteries as well (they never seemed to reach a 'charged' state, per the Trimetric). Thanks for any help!
|
Replies:
Posted By: D Plex
Date Posted: 17 Jul 2017 at 12:43pm
|
Also, some specifics on my batteries: According to Interstate (the manufacturer), Bulk Charge should be 14.4, Absorption should be 15.5, and Float should be 13.2 (the current reading). I guess it's possible that the batteries charged and have settled to that 13.2 float, but perhaps the R-pod charger limits the bulk charge to less than 14.4 - hence the Trimetric not reading them as 'charged'?
|
|