R-pod Owners Forum Homepage

This site is free to use.
Donations benefit a non-profit Girls Softball organization

Forum Home Forum Home > R-pod Discussion Forums > Podmods, Maintenance, Tips and Tricks
  New Posts New Posts RSS Feed: Sensors
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Topic ClosedSensors
 Post Reply Post Reply Page  12>
Author
Message
  Share Topic Share Topic  Topic Search Topic Search  Topic Options Topic Options
dathos View Drop Down
Newbie
Newbie


Joined: 17 Oct 2016
Online Status: Offline
Posts: 4 		Direct Link To This Post Topic: Sensors
    Posted: 23 Apr 2017 at 4:17pm
I'm a newbie, not only to an R-Pod but to travel trailering at all. I ran fresh city water into my 2015 R-Pod 171 and water comes out of the faucets but the sensor still registers as empty. I assume the sensor isn't working. How do you know whether the tank is full if the sensor doesn't work?
Back to Top
McCall View Drop Down
Groupie
Groupie
Avatar

Joined: 16 Mar 2017
Location: McCall, ID
Online Status: Offline
Posts: 49 		Direct Link To This Post Posted: 23 Apr 2017 at 4:27pm
Did you fill the holding tank?  Or did you just hook up to city water, which does not fill the tank?
Gary E
McCall, Idaho
2017 RP179

https://www.instagram.com/erttergary/
Back to Top
dathos View Drop Down
Newbie
Newbie


Joined: 17 Oct 2016
Online Status: Offline
Posts: 4 		Direct Link To This Post Posted: 23 Apr 2017 at 4:32pm
Ooooh. I just hooked up the city water. How do you fill the holding tank?
Back to Top
McCall View Drop Down
Groupie
Groupie
Avatar

Joined: 16 Mar 2017
Location: McCall, ID
Online Status: Offline
Posts: 49 		Direct Link To This Post Posted: 23 Apr 2017 at 4:39pm
On my 179 it's labeled "Fresh Water Connection".  It's not really a connection, it's a fill port.
Gary E
McCall, Idaho
2017 RP179

https://www.instagram.com/erttergary/
Back to Top
cjscinta View Drop Down
Groupie
Groupie
Avatar

Joined: 21 Nov 2016
Location: Franklin, TN
Online Status: Offline
Posts: 84 		Direct Link To This Post Posted: 23 Apr 2017 at 4:41pm
The gauge and sensor is for your holding tanks. It has nothing to do with the city water connection. There is no gauge for that. If there is adequate pressure the city water hookup works great. If there is not adequate pressure at the campground you must fill your fresh water holding tank up and turn the water pump on. If you are using city water leave the pump off. 
2017 R-pod 179
Back to Top
dathos View Drop Down
Newbie
Newbie


Joined: 17 Oct 2016
Online Status: Offline
Posts: 4 		Direct Link To This Post Posted: 23 Apr 2017 at 4:42pm
Gotcha. Thanks!  BTW, just thinking then when hooked up to city water does the hot water tank fill?  I read somewhere that it does when filling the tank.  Wish I had a manual!
Back to Top
mcarter View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 07 Apr 2016
Location: Greenbrier, TN
Online Status: Offline
Posts: 3419 		Direct Link To This Post Posted: 23 Apr 2017 at 4:43pm
+1, good answer.
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
Back to Top
cjscinta View Drop Down
Groupie
Groupie
Avatar

Joined: 21 Nov 2016
Location: Franklin, TN
Online Status: Offline
Posts: 84 		Direct Link To This Post Posted: 23 Apr 2017 at 4:51pm
Yes it does fill the hot water tank. Open the hot water side and draw the air out. You can go outside and pull the pressure relief valve to check it. If water comes out it is full. Don't turn the hot water switches on unless you know there is water in the tank. The inside one is propane ( quicker recovery) and the outside switch is for the electric heating element when you have ground power. Use both if you want the fastest recovery. Don't forget to turn them off when you are through camping so you don't burn the element out. 
2017 R-pod 179
Back to Top
mcarter View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 07 Apr 2016
Location: Greenbrier, TN
Online Status: Offline
Posts: 3419 		Direct Link To This Post Posted: 23 Apr 2017 at 4:51pm
The hot water tank fills when you are using city water or the holding tank, with pump on, provided you have valves in correct position.
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
Back to Top
dathos View Drop Down
Newbie
Newbie


Joined: 17 Oct 2016
Online Status: Offline
Posts: 4 		Direct Link To This Post Posted: 23 Apr 2017 at 4:58pm
Thanks to all. Smile
Back to Top
 Post Reply Post Reply Page  12>

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.64
Copyright ©2001-2009 Web Wiz