Comments

Due to the R dome poles not fitting into the storage area properly, I pulled the bed panels off to cut out a section of the forward water heater panel so the poles could extend into that compartment.
While working there I discovered a lot of sawdust, wood bits, pieces of wire and other debris left over from manufacturing. After seeing that, I did a closer look at some of the usually un-seen areas and found screws started but not driven in, cracked support members around attachment screws, and other debris.
Most of my working life was involved in quality control so maybe I'm more sensitive to what impresses customers (either positively, or negatively), but some of the mentioned issues strike me as unprofessional at best.

+1 

It is not just the manufacturer, the dealer usually charges you for "dealer" prep! They should go through the trailer head to toe to guarantee that things are in order!