Author |
Share Topic Topic Search Topic Options
|
Sea pod
Newbie
Joined: 22 May 2014
Location: Cayucos, ca
Online Status: Offline
Posts: 13
|
Topic: Water Tank Beam Posted: 03 Sep 2014 at 10:48pm |
Did the same....through bolted the support on fresh water tank. Like to travel with it full, it seems to pull better with a lower center of gravity. Just finished 3200 miles through the western states with thunder showers and high winds..no problems.
|
TV..ford 350
Co pilot....Noreen
Navigator...rosie
|
|
frogpod
Groupie
Joined: 17 Aug 2014
Location: Grand Rapids, M
Online Status: Offline
Posts: 40
|
Posted: 03 Sep 2014 at 8:01pm |
Bought a used 2010 R171. Checked the tank brackets after reading these posts. THANKS FOR SHARING. All the bars were the correct length but only 2 screws in each bracket. One of the screws on the fresh water tank was sheared off....leaving one cheap screw holding it up. Added a bolt through the center of each bracket and also put in the missing screws so there now are three screws and one bolt in each bracket. A bolt in the center of the brackets and through the center of the frame should not make the frame weaker....if I recall my structural engineering classes correctly.
|
Leo and Tami
with Coltrane the Jack Russell Terrier
2010 Rpod 171
2003 Toyota Tacoma TRD
|
|
J&Jcf
Groupie
Joined: 17 Aug 2014
Location: central Florida
Online Status: Offline
Posts: 90
|
Posted: 30 Aug 2014 at 1:50pm |
Checked my tank supports and all needed tightening. Only one bolt needed a washer behind it.other side of bracket was tight to frame.It was like the bracket was warped or welded poorly. Aok now.
This forum has been very helpful in researching for purchase and information to keep up dated
2011 171 pod purchased recently.
|
J. - 2011 rpod 171
|
|
Blue's Pod
Groupie
Joined: 25 Aug 2014
Online Status: Offline
Posts: 61
|
Posted: 28 Aug 2014 at 8:18pm |
Today our new 2015 r-pod 171 was delivered. Thanks to this forum and all the helpful information hubby was underneath checking this out. Two of the new screws were loose on the door side of the pod and there was the gap issue. He is working on getting it fixed. The only miles on the pod are from FR to Ohio, and then to NC.
Also some of the wire wrap underneath had come loose. He refit the wires into the wrap and added some wrap on the wires to the sensors in the water and holding tanks that were not wrapped.
|
|
wildfire305
Groupie
Joined: 22 Jul 2014
Location: Erlanger, KY
Online Status: Offline
Posts: 85
|
Posted: 04 Aug 2014 at 7:32pm |
Mine only has two screws in each side. That should be enough until they get rusty and their shear strength is lowered.
|
2005 Dodge Durango 4.7 V8
OLD Tow Vehicle 2004 Honda Odyssey
2015 RP179 "73b"
OLD 2005 Viking Saga 2480ST popup
|
|
travelksjt
Newbie
Joined: 21 Oct 2013
Location: Vermont
Online Status: Offline
Posts: 9
|
Posted: 04 Aug 2014 at 7:05pm |
Hi All my wife and i own a 2013 177. I looked under and found pretty much the samething as everyone else with a twist. My water tank and waste take only have screws in the bottom holes not the top... One of the water brackets has a twist on it to. I for the heck of it check to see if the bolts fell out of the top holes. Get this they were never drilled for bolts or anything How could FR let this go? the space for those top holes are very hard to get to. I am not sure if just replacing longer bolts in the smaller holes is enough to carry the weight. Anyone else have any thoughts on this. Thanks John i pull my 177 with a 2011 four runner
|
|
wildfire305
Groupie
Joined: 22 Jul 2014
Location: Erlanger, KY
Online Status: Offline
Posts: 85
|
Posted: 03 Aug 2014 at 7:13pm |
Several Tanks have to fall out before a recall would ever be issued. Business reputation is damaged by issuing a recall and they're not going to do it unless there is a "realized hazard" not just a "perceived hazard". The burden of proof is unfortunately on the consumer. Heaven forbid a company or person take responsibility for their own actions in today's society.
|
2005 Dodge Durango 4.7 V8
OLD Tow Vehicle 2004 Honda Odyssey
2015 RP179 "73b"
OLD 2005 Viking Saga 2480ST popup
|
|
David and Danette
podders Helping podders - pHp
Joined: 24 Nov 2009
Online Status: Offline
Posts: 1214
|
Posted: 03 Aug 2014 at 3:12pm |
I would think that if this was a automobile there would be a recall. With the r-pods mentioned that have problems with brackets and screws that should be of some concern for safety that Forest River would want to have the holding tanks secured properly. RV's are very different from the automobile industry.
|
2018 Vista Cruiser 19BFD (2018-
2012 Vibe 6503 (2014-2019)
2009 r-pod 171 (2009-2014)
Middle Tn
2014 Ram 1500 Quad cab
|
|
wildfire305
Groupie
Joined: 22 Jul 2014
Location: Erlanger, KY
Online Status: Offline
Posts: 85
|
Posted: 03 Aug 2014 at 9:54am |
Clearly the brackets are not the right size for the trailers, or the tolerances for them or the frame spec is way too loose.
|
2005 Dodge Durango 4.7 V8
OLD Tow Vehicle 2004 Honda Odyssey
2015 RP179 "73b"
OLD 2005 Viking Saga 2480ST popup
|
|
Leo B
podders Helping podders - pHp
Joined: 13 Jan 2012
Location: Lyndonville, VT
Online Status: Offline
Posts: 4508
|
Posted: 03 Aug 2014 at 9:52am |
Budward,
I also checked the exposed wood spot that you found that was on both sides of the step and that was all sealed. I agree a new guy or someone who take pride in their work!! ( getting to be a rare find!!!)
|
Leo & Melissa Bachand
2017 Ford F150
2021 Vista Cruiser 19 csk
Previously owned
2015 Rpod 179
2010 Rpod 171
|
|