R-pod Owners Forum Homepage

This site is free to use.
Donations benefit a non-profit Girls Softball organization

Forum Home Forum Home > R-pod Discussion Forums > Warranty, Service and Recall Bulletins
  New Posts New Posts RSS Feed: Outriggers and over torsioned axle
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Outriggers and over torsioned axle
 Post Reply Post Reply Page  <1 345
Author
Message
  Share Topic Share Topic  Topic Search Topic Search  Topic Options Topic Options
Austintaco View Drop Down
Newbie
Newbie


Joined: 24 Jul 2023
Location: Austin, TX
Online Status: Offline
Posts: 20 		Post Options Post Options   Quote Austintaco Quote  Post ReplyReply Direct Link To This Post Topic: Outriggers and over torsioned axle
    Posted: 11 Aug 2023 at 5:39pm
Bowcat,
I’m new to the scene and not as well versed as others, but I have read on here and the FB group that if it’s sagging too much, you will need to jack it up, let it sit and adjust, and then try some more. Where are you located in Texas? I would be curious to see what the sag looks like and what to look out for.
2003 Toyota Tacoma
1984 Toyota 4runner
2016 Rpod HRE 179
Back to Top
Bowcat66 View Drop Down
Newbie
Newbie
Avatar

Joined: 25 May 2023
Location: Texas
Online Status: Offline
Posts: 16 		Post Options Post Options   Quote Bowcat66 Quote  Post ReplyReply Direct Link To This Post Posted: 11 Aug 2023 at 6:29pm
I am located in Pampa, Texas. Put a square against the frame and the floor under your slide, it should be a 90 degree angle. Mine is approx. 3/16" - 1/4" off. This is durle to the weight of the slide out when extended. The outriggers should help.
God Bless America! Go NAVY!!
Back to Top
StephenH View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 29 Nov 2015
Location: Wake Forest, NC
Online Status: Offline
Posts: 6217 		Post Options Post Options   Quote StephenH Quote  Post ReplyReply Direct Link To This Post Posted: 11 Aug 2023 at 9:38pm
Originally posted by Bowcat66

I have a 2016 180 that has zero outriggers installed. I do show a small amount of sagging, but even when I jack it up, it doesn't square it up. I have the outriggers ready to install, but am now confused because it doesn't square up. Have any of you had this issue? And did you go ahead an install the outriggers?
Once the floor frame is bent, it will take some doing to get it to square up. I saw that it has already been suggested to jack it up, let it sit, then jack some more. Hopefully, that will work for you.
StephenH
Happy is the man that findeth wisdom,...

ouR escaPOD mods
Former RPod 179
Current Cherokee Grey Wolf 24 JS
Back to Top
 Post Reply Post Reply Page  <1 345

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.64
Copyright ©2001-2009 Web Wiz