Installing new windows - Event Date: 03 Jun 2017

A few weeks ago I asked if anyone had used Camping World for repairs or modifications to their pods, as I was considering having them install windows in my pod. The consensus was that I should do it myself not only to save money but would probably do a better job.

So I finally bit the bullet and installed an opening window in the door of my 172 model today. It was quite easy to remove the door so I could work on it in my shop. I had one problem with cutting the hole. For some reason my jig saw base plate didn't stay at 90 degrees to the blade, so the edge of the cutout had a bevel on it. The size of the opening on the exterior face wound up smaller than the opening on the interior face. So after a few times shaving off material the window itself went in. The trim ring fit on the first try.

So the window is in, looks good, and lets much needed daylight into the dark end of the pod. Next up will be to find and install a small window at each bunk for additional light and air flow. For those I might use a good sharp handsaw instead of the jigsaw.

My thanks to you podders who explained in words and pictures how to do this project. The information was greatly appreciated!
mountainman

Really close to giving it a try and putting a window in

Make sure you have good quality blades and slower is better. Jigsaws are famous for beveled cuts and there can be numerous reasons. Any kind of side pressure, a blade that bends with temp, or trying to cut to fast. Make sure you have a good saw, cheaper is not better. Support the opening while you cut, you don't want piece to break off at end of cut.

Please post if you do find such windows. It is either that or finding some sort of cover like that for the Fantastic Fan that can be installed to allow the window to be open for ventilation while keeping the rain out.