R-pod Owners Forum Homepage

This site is free to use.
Donations benefit a non-profit Girls Softball organization

Forum Home Forum Home > R-pod Discussion Forums > I need HELP!!!
  New Posts New Posts RSS Feed: No power from Gfci
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Topic ClosedNo power from Gfci
 Post Reply Post Reply Page  <123>
Author
Message Reverse Sort Order
  Share Topic Share Topic  Topic Search Topic Search  Topic Options Topic Options
Badweissenbier View Drop Down
Groupie
Groupie


Joined: 26 Oct 2019
Location: WV
Online Status: Offline
Posts: 41 		Direct Link To This Post Topic: No power from Gfci
    Posted: 13 Oct 2020 at 8:07pm
Looking on my phone so I may have missed the answer. My apologies if I did.

A GFCI will not reset unless there is power to it. If your not plugged in to shore power or a generator it won’t reset.

Ie if you unplugged your trailer from shore power(110v) you can push the reset all you want it won’t do anything.
Back to Top
richardb09 View Drop Down
Newbie
Newbie


Joined: 13 Oct 2020
Location: CA
Online Status: Offline
Posts: 14 		Direct Link To This Post Posted: 13 Oct 2020 at 7:01pm
Thanks Pod_Geek.  Found the inverter behind a panel on the left where the outdoor kitchen slides in, 12amp breaker was popped.  Smile
Back to Top
richardb09 View Drop Down
Newbie
Newbie


Joined: 13 Oct 2020
Location: CA
Online Status: Offline
Posts: 14 		Direct Link To This Post Posted: 13 Oct 2020 at 4:09pm
The RP190 inverter switch is up above the breaker panel right when you come in the door.  So I'll start in the break panel area.
Back to Top
Pod_Geek View Drop Down
Senior Member
Senior Member


Joined: 04 Dec 2019
Location: Colorado
Online Status: Offline
Posts: 261 		Direct Link To This Post Posted: 13 Oct 2020 at 3:45pm
Originally posted by richardb09

Great, where was your inverter located?

Not 100% sure because the dealer had to track it down.  They initially had no clue that there was a breaker on the inverter.  Since the inverter on/off switch is near the microwave I suspect it's in that area.  I would snoop around wherever your on/off switch is (recall that you have a 190 and I have a 195).
2020.5 R-Pod 195 Hood River
2018 RAM 2500 6.4L
Back to Top
richardb09 View Drop Down
Newbie
Newbie


Joined: 13 Oct 2020
Location: CA
Online Status: Offline
Posts: 14 		Direct Link To This Post Posted: 13 Oct 2020 at 3:38pm
Great, where was your inverter located?

Rich
Back to Top
Pod_Geek View Drop Down
Senior Member
Senior Member


Joined: 04 Dec 2019
Location: Colorado
Online Status: Offline
Posts: 261 		Direct Link To This Post Posted: 13 Oct 2020 at 3:29pm
Originally posted by richardb09

... Is there somewhere else, from the inverter possibly, that feeds the GFCI outlet in the bathroom?


My 195 has a 12-Amp breaker on the inverter that will trip if you hit the system with a 1500-watt space heater cranked up to full power (works fine at 1/2 power).  This is regardless of whether you're actually using the inverter, (I wasn't) as it's a pass-through system.  Found out the hard way.  Once that baby trips you'll have no power to any of the 110 outlets until you reset it.
2020.5 R-Pod 195 Hood River
2018 RAM 2500 6.4L
Back to Top
offgrid View Drop Down
Senior Member
Senior Member


Joined: 23 Jul 2018
Online Status: Offline
Posts: 5290 		Direct Link To This Post Posted: 13 Oct 2020 at 3:20pm
I don't know how the new rpods with inverters have the inverters wired, but the outlets aren't being supplied by the inverter are they? A little 1kw inverter isn't going to be able to supply an electric heater and water kettle. 
1994 Chinook Concourse
1995 RV6A Experimental Aircraft
2015 Rpod 179 - sold
Back to Top
richardb09 View Drop Down
Newbie
Newbie


Joined: 13 Oct 2020
Location: CA
Online Status: Offline
Posts: 14 		Direct Link To This Post Posted: 13 Oct 2020 at 2:55pm
Question about the inverter - I plugged in both an electric heater and an electric hot water kettle.  I though OK I tripped the breaker.  Reset all the breakers in the Rpod panel, none were obviously tripped, still no power to any of the GFCI protected outlets.  I then attempted to reset, red button, the GFCI outlet in the bathroom and it would not click in.  The black reset button clicked once and that was it.  I pulled the GFCI outlet and there is no 120V AC going to the Line side.  My 2021 RP190 has a solar panel and inverter.  Is there somewhere else, from the inverter possibly, that feeds the GFCI outlet in the bathroom?
Back to Top
StephenH View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 29 Nov 2015
Location: Wake Forest, NC
Online Status: Offline
Posts: 6418 		Direct Link To This Post Posted: 04 Jul 2020 at 6:29pm
If you don't have access to AC power, then you will need to plug your tow vehicle's connector to charge your battery. Even better would be to use jumper cables to charge the battery as many trailer connectors are much more limited in the amount of power they can supply. Jumper cables will charge faster in that case. Or, as I stated earlier, solar or a generator.
StephenH
Happy is the man that findeth wisdom,...

ouR escaPOD mods
Former RPod 179
Current Cherokee Grey Wolf 24 JS
Back to Top
mcarter View Drop Down
podders Helping podders - pHp
podders Helping podders - pHp
Avatar

Joined: 07 Apr 2016
Location: Greenbrier, TN
Online Status: Offline
Posts: 3419 		Direct Link To This Post Posted: 04 Jul 2020 at 5:12pm
+1 to OG, you don't have AC on battery only.
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
Back to Top
 Post Reply Post Reply Page  <123>

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.64
Copyright ©2001-2009 Web Wiz