![]() |
|
Post Reply ![]() |
Page 123> |
Author | |
StephenH ![]() podders Helping podders - pHp ![]() ![]() Joined: 29 Nov 2015 Location: Wake Forest, NC Online Status: Offline Posts: 6417 |
![]() Posted: 13 Jul 2018 at 10:42pm |
If it is under 2 years old, it is under warranty by WFCO. Go to their site and follow the troubleshooting steps. If it is bad, you can request replacement. I did so and now have a spare because I had to replace it during a trip. The one I purchased is still going strong, but I keep the one sent under warranty available just in case the installed one goes bad again. We've been over some very rough roads on our last trip. It has not affected the converter. I'm not sure vibration is the cause of failure.
|
|
StephenH
Happy is the man that findeth wisdom,... ouR escaPOD mods Former RPod 179 Current Cherokee Grey Wolf 24 JS |
|
![]() |
|
Richand Cindy ![]() Senior Member ![]() ![]() Joined: 16 Apr 2016 Location: New Jersey Online Status: Offline Posts: 328 |
![]() |
On our unit the circuit board was cracked. It seems that the converter sits right above the axle and is very susceptible to vibration.So after a long stretch of very rough road (we had to slowdown to 25 mph the vibration was so bad) we noticed it stopped working. Dealer replaced converter under warranty. So not simple fix.
|
|
OLD 2017.5 RPOD 180 + 2015 Jeep Cherokee Trailhawk
NEW: 2018 Passport Elite 23RB + 2017 Ram 1500 Diesel |
|
![]() |
|
Podski4us ![]() Newbie ![]() Joined: 10 Jul 2018 Online Status: Offline Posts: 1 |
![]() |
Hello from another newbie. Sorry to interrupt and not too sure where to post my question. I too have a 180 and the power converter is dead. For what I'm reading everybody that had a problem with it seems to go on replacing it. Does anybody knows what really gone bad to it. Maybe it's just a matter of replacing resistor or capacitor. Please help.
Thanks Efren |
|
![]() |
|
StephenH ![]() podders Helping podders - pHp ![]() ![]() Joined: 29 Nov 2015 Location: Wake Forest, NC Online Status: Offline Posts: 6417 |
![]() |
When I had the dual 6V batteries out, I kept them hooked together and used my 12V charger with them. In the 'Pod, the converter takes care of them just fine. ---------(+) 6V Battery 1 (-)----------(+) 6V Battery 2 (-)------ Connect+ Connect- |
|
StephenH
Happy is the man that findeth wisdom,... ouR escaPOD mods Former RPod 179 Current Cherokee Grey Wolf 24 JS |
|
![]() |
|
landshark ![]() Newbie ![]() Joined: 19 Aug 2015 Online Status: Offline Posts: 27 |
![]() |
Yes, I charge my two 6 Volt batteries (US Batteries-US2200 232 amp hours 20 hr rate) together in series. I use the NOCO Genius G7200 battery charger. I also use a Renolgy solar battery panel, 100 Watts to keep my batteries charged when boondocking
The charger can do 24 Volt charging which is why I originally bought it as I have a Toyota Land Cruiser HJ60 that runs on 24 Volt. Bob
|
|
![]() |
|
Vernonymous ![]() Newbie ![]() ![]() Joined: 05 May 2018 Location: WA Online Status: Offline Posts: 3 |
![]() |
Newbie Vernonymous here. Landshark, you mentioned using a 12 volt battery charger for two 6 volt batteries. Are you charging the two batteries together? I need to buy a charger and don't know if I need something to charge them individually or together. With this in mind, what charger do the rest of you recommend for two Trojan T-105 batteries?
|
|
![]() |
|
landshark ![]() Newbie ![]() Joined: 19 Aug 2015 Online Status: Offline Posts: 27 |
![]() |
Yep, miss the old RS. I have sent a request in to Progressive Dynamics, told them my dog ate the jumper harness.
Bob
|
|
![]() |
|
StephenH ![]() podders Helping podders - pHp ![]() ![]() Joined: 29 Nov 2015 Location: Wake Forest, NC Online Status: Offline Posts: 6417 |
![]() |
Glad you got it figured out. Sorry I can't help you with the 4-pin jumper wire. Too bad Radio Shack isn't around anymore.
|
|
StephenH
Happy is the man that findeth wisdom,... ouR escaPOD mods Former RPod 179 Current Cherokee Grey Wolf 24 JS |
|
![]() |
|
landshark ![]() Newbie ![]() Joined: 19 Aug 2015 Online Status: Offline Posts: 27 |
![]() |
Man, I can not believe I got the polarity wrong? I was so sure I had it right that I did not even bother to check the polarity fuses. After walking away from the problem, Stephen H comments got me to go back and review my wiring. After install of 2 new fuses and connecting the white and black wires properly, everything works great. Now I just need where I can get a new 4 pin jumper wire to replace the one I fried. Thanks everyone. Bob
|
|
![]() |
|
StephenH ![]() podders Helping podders - pHp ![]() ![]() Joined: 29 Nov 2015 Location: Wake Forest, NC Online Status: Offline Posts: 6417 |
![]() |
Smoking and melting wires is never good and indicates a serious wiring issue. Are you sure your polarity is correct?
|
|
StephenH
Happy is the man that findeth wisdom,... ouR escaPOD mods Former RPod 179 Current Cherokee Grey Wolf 24 JS |
|
![]() |
Post Reply ![]() |
Page 123> |
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |